Speed 300-500mm/S Side PCB cutter separator Germany CAB blade for PCB size 0.3-3.5mm thickness length from 400mm to 1200mm

Cách gắn cuộn băng cho RF08AS RF12AS RF16AS RF24AS RF32AS RF44AS RF56AS

Bạn đang ở đây: Nhà » Bài viết kỹ thuật » How to attach a tape reel for RF08AS RF12AS RF16AS RF24AS RF32AS RF44AS RF56AS


1. Đặt bộ nạp SMT điện sê-ri RF trên làn bên trái của giá đỡ thiết lập Bộ nạp cho bộ nạp điện. Sử dụng cần nhả đá để cố định nó vào vị trí bằng cách đập chốt dẫn hướng F vào tấm định vị.

2. Attach the tape reel to the tape holder of the Feeder setup stand and feed the tape into the Electric SMT label feeder.

3. Align the feeding holes of the carrier tape with the teeth of the sprocket wheel on the feeder.

4. Pass the cover tape through a slit and close the upper cover of the feeder.

5. Guide the cover tape through the upper side of the guide roller and the lower side of the tensioner roller.

6. Push the pull idler arm to insert the cover tape into the gap in the space of the gear.

7. Press and hold the switch button on the operation panel to rotate the pull gear and pull the cover tape. Stop the gear when the tension sensor turns on.

8. Push the button on the operating panel to feed the carrier tape into the Electric SMT feeder. Wait for the tape to reach the supply location.
Cut the end of the tape protruding from the tape ejecting slot (about 3mm or less) and attach the tape to the mounter. With these 9 steps, you can easily set up an Electric SMT feeder or a Mechanical feeder for your SMT assembly line, improving your production efficiency.

Loại: Bài viết kỹ thuật | Thẻ:
Bản quyền 2008-2025 Thâm Quyến FS thiết bị CO.,LTD Tất cả các quyền được bảo lưu.
Sơ đồ trang web | Trên cùng↑