제품
검색
온라인 서비스
| 예비 부품(24 H)-피오나 |  |
| 장비-Lee | |
| 유지 보수 소모품 - Jessica | |
FS/PCB 조립 장비 & 부품 SMT 액세서리 공급 업체 - 파나소닉 | 야마하 | 후지산 | 삼성 | 히타치 | 쥬키
lable 프린터 헤드 얼룩말 Z4M-S4M 203 DPI G41401M-G79056-1M
|
|
제브라 라벨 프린터에 사용: Z4M S4M Z4M Plus
해상도：200 DPI를 203 DPI는 300 DPI는
Printing head number:G41400M G79056-1M G41401M
Print width:4.09″(104밀리미터)
바코드 프린터의 일일 유지 보수:
리본 한 롤을 인쇄한 후, 바코드 프린트 헤드 청소. This maintains print quality and extends the life of the printhead. The specific operations are as follows:
.Print head cleaning
Turn off the power, flip the print head up, and remove the ribbon and label stock. Use a cotton swab or a cotton wipe soaked in a little print head cleaning solution to gently wipe until clean. Finally, wipe again with a dry cotton swab.
. Cleaning of the rollers
Clean the roller with a cotton wipe or cotton swab soaked in a little 75% alcohol. The method is to wipe the roller with one hand and rotate the roller with the other hand, and then dry it after it is clean.
Appeal two maintenance at least once every 3 일. If the printer is used frequently, use it once a day.
.Cleaning of the drive train and cleaning of the inside of the case
Because the general label paper is self-adhesive, it is easy to stand on the drive shaft and channel, and dust will directly affect the printer effect. So it needs to be done once a week. The method is to use a cotton swab or cotton wipe soaked in alcohol to wipe the surface of each shaft and channel of the transmission and the dust in the chassis. Dry after cleaning.
. Sensor cleaning
The sensor includes the ribbon sensor and the label sensor, and its location is shown in the manual. 일반적으로, it is cleaned once a month to 3 개월. The method is to blow the dust on the sensor with a blower device (suction ball)
범주: 주변기기 SMT 부품 보조 기계 | 태그: 피더 캘리브레이션 지그
이 범주의 다른 항목
요청 양식