| Numéro de kit: |
XFW1KS5A00 |
| Nom du kit: |
Chargeur de bande 8mm double détection d’épissure Type A |
| キット名称: |
T/F;8mmダブル;スプライシング検出;タイプA |
| Enrouleur de composants: |
Bobines de ruban de 8 mm de largeur |
| Électronique ou mécanique: |
Électronique |
| Millésime: |
Année 2016+ |
| Marque: |
Panasonic |
| Nouveau ou original: |
Optionnel |
| Emballage: |
10pcs par CARTON |
| Poids brut: |
Environ 1 kg |
| Delai: |
3 jours ouvrables |
| Mode d’expédition: |
Par avion |
| Modalités de paiement: |
T/T |
|
|
Chargeur de bandes; 12;16 mm; Détection d’épissure; Type A，
Chacun des composants de Feeder affecte la façon dont la machine prélève les composants. Voici quelques zones courantes de dommages. Que pouvons-nous faire à leur sujet ??
Partie: Bec, couvrir (Couverture du matériau du rouleau) , Couverture avant, boucle de sécurité, etc. Sont Phénomène d’usure, un peu pas évident.
Feeder doesn’t work in the following ways:
. Don’t roll the tape
Is the beak or the inner cover wear these two, the identification method is to use the hand to step-by-step speed down the inner cover reverse push, the inner cover can be reversed, indicating wear. We can usually see it with our eyes.
. Throwing components (for feeder cases only)
The main thing is the location of the material, the feeder cover, which affects throwing components happen. Location: Use Good Feeder to adjust the vision in the calibrator, good Ng feeder to compare. (See Below picture 1) to adjust the feeder’s head to the top right to make it look better than the previous feeder (left or right doesn’t matter) . Tape guide: mainly wear and tear, not match. What’s necessary is to put on the right one. If you don’t have an accessory for exchange, use pliers to bend the outside of a tape guide inward so it sticks firmly.(picture 2)
Feeder in the SMT industry is feeding equipment. Its function is to install SMD components on the feeder, and the feeder provides components for the high-speed Mount placement machine for placement. Par exemple, there is a kind of PCB that needs to mount 10 kinds of components, then 10 feeders are needed to install the components to supply the PNP.
Feeder refacciones Panasonic of 8mm,24-32mm N610133537AA in stock:
